These photos i mounted up by using foam board i placed each images on foam boarded, glued it down and then cut each one out by using a knife and a metal rulers to get a sharp straight line, once each image was cut out i then placed double sided sticky tape to the back of each image and placed them on one single pice of foam board to create this final pice.

window mount

The photos below i created by cutting out each window fame, i had to work out all the sizes and measurements for this to make sure the image being placed fitted in perfectly to the mount, after i have marked out all the lines on the board i then begin to cut out the centre square, i use a special knife which cuts out on an angle which makes the white rim around the photo.

The image above is some of the measurements i used to create the window mounts.

These two photos i placed the window mounted photos on to white foam board to create a second frame the white frame is 5cm wide around the whole image.